Rustoleum - Epoxyshield Ultra is a quick-drying single pack water-based floor coating (epoxy-modified acrylic) for light to medium duty (normal foot traffic/limited vehicular traffic). Good resistance to diesel, motor oil, coolant fluid, various household chemicals and most types of tyre.

Reccomended Use

EpoxyShield 5200 ULTRA can be applied on concrete floors which are completely clean, dry and treated with EpoxyShield Sealer 5220. Do not apply to smooth and completely sealed concrete or concrete containing a curing compound. Such substrates will prevent a good adhesion. EpoxyShield 5200 ULTRA can also be applied on old good adhering coatings.

Surface Preparation

Remove oil, grease and all other contaminants with EpoxyShield Cleaner/Degreaser 2901 in combination with high pressure cleaning. Allow new concrete to set for at least 30 days before applying a coating. Remove laitance, loose and damaged concrete by sandblasting or etching with RUSTOLEUM Surfa-Etch 108. Repair all holes and cracks with EpoxyShield concrete repair products. Always pre-treat absorbent, porous surfaces with EpoxyShield Sealer 5220. Roughen or blast well-sealed and smooth concrete and treat with Epoxyshield Sealer 5220 or apply a coat RUSTOLEUM 3333 Super Adhesive. Roughen still-intact floor coatings to ensure good adherence. Remove poorly adhering old coatings with wire brush and sandpaper. During application the surface must be clean and dry.

Application

Application & Thinning: Brush

Product is ready for use, dilution is not necessary.

Application & Thinning: Roller

Product is ready for use, dilution is not necessary. Use a nylon paint roller (ca. 12 mm). In case of roller application it can be necessary to apply 2 coats in order to achieve the prescribed film thickness.

Cleaning Of Equipment / Spills

Direct after application with water and soap.