Rustoleum - Epoxyshield Sealer is a one component, water-based, concrete sealer based on a vinyl acrylic binder. It reduces dust production and simplifies cleaning.

Features

• Single pack, easy to apply
• Non yellowing clear finish (gloss)
• Touch dry after just 1 hour
• Ideal primer for EpoxyShield ULTRA coatings

Recommended Use 

When EpoxyShield® Sealer is used as a finish, apply 2 coats. Rustoleum EpoxyShield® Sealer can also be used as a sealer/impregnation primer for EpoxyShield® 5200 ULTRA. Apply the sealer on bare and clean concrete floors.

Surface Preparation

Apply the product only on fully clean and dry concrete surfaces. Do not apply on smooth or very dense concrete or concretewhich contains curing compound. Remove all oil, grease and other dirt using EpoxyShield® Cleaner/Degreaser 2901. Newconcrete has to cure for minimal 30 days. All laitance, loose or unsound concrete should preferably be removed by blasting, cutting or etching with RUST-OLEUM Surfa-Etch 108 Etching Solution. Repair all holes and cracks with EpoxyShield® concrete repair products. Very dense and smooth concrete should first be abrasive blasted (or etching). During application the substrate should be clean and dry.

Directions For Use

Mix the product prior for use.

Application Conditions 

Temperature of air, substrate and coating material between 10 and 35°C, relative humidity below85%. The substrate temperature must be at least 3°C above dewpoint. Ventilatewell during and after application.

Application & Thinning: Brush 

Product is ready for use. Thinning is not necessary.

Application & Thinning: Roller 

Product is ready for use. Thinning is not necessary.

Theoretical Coverage 

Maximum 10 m² per litre.

Practical Consumption

Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.