Orders before 12pm dispatched same day
Orders before 12pm dispatched same day
Rustoleum 3333 - Super Adhesive Primer is a water-based epoxy primer for use on on non-porous, dense mineral substrates.
Rustoleum 3333 - Super Adhesive Primer is a water-based epoxy primer for use on on non-porous, dense mineral substrates.
Features
Recommended Use
Super Adhesive 3333 should be used on non-porous, dense mineral substrates like tiles or power floated concrete; non-ferrous metals like stainless steel, aluminium or new hot-dip galvanized steel and thermosetting plastics like fibreglass-reinforced polyester or epoxy. Resists light to moderate abrasion, intermittent high humidity and moisture, regular chemical cleaning and spillage of chemicals if recoated with the appropriate RUST-OLEUM System; can be recoated with practically all RUST-OLEUM Epoxy, Polyurethane, Chlorinated Rubber/Vinyl and Acrylic coatings. Classified Class 1 Surface Spread of Flame according BS 476; part 7: 1987.
Surface Preperation
Remove grease, oil and all other surface contaminations with RUST-OLEUM FK 111 Cleaning Solution or by alkaline or high pressure (steam) cleaning. New concrete should cure and dry for at least 30 days prior to the application of the coatings. The surface must be clean and may be slightly damp during application.
Directions For Use
Stir individual components thoroughly before mixing them together. Use the boxing method or a low speed mixer.
Application Conditions
Temperature of air and substrate between 10 and 35°C and relative humidity below 70%. The substrate temperature must be at least 5°C above dewpoint.
Application & Thinning: Brush
Always dilutewith 20% volume with water. Use brushes based on a mixture of synthetic/natural bristles. Check wet film thickness, avoid excessive film thickness. Preferably use disposable brushes.
Application & Thinning: Roller
Always dilutewith 20% volume with water. Use HD foam roller. Check wet film thickness, avoid excessive film thickness. Preferably use disposable rollers.
Application & Thinning: Air-Atomised Spray
Up to 20% volume with water. Spray: Gravity cup and pressure cup. Tip size: 1.2 -2.0 mm. Atomizing pressure: 2 - 4 bar. Check wet film thickness, avoid excessive film thickness.
Data sheet
Specific References
No customer reviews for the moment.