Rustoleum 3202 Galvinoleum is a single pack super adhesion primer for galvanised steel, plastic or other smooth surfaces.

Recommended Use

Galvinoleum 3202 should be used on galvanised steel, stainless steel, aluminium, copper, glass, porcelain and other smooth, dense surfaces. Only intended for brush application. Can be recoated with Alkythane® 7500, improving the adhesion on very smooth and nonporous surfaces.

Surface Preperation

Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam) cleaning in combination with appropriate detergents. Remove previous coatings completely. Remove salts, 'white rust', etc., by washing with Surfa-Etch 108 Etching Solution. The surface must be clean and dry during application.

Directions For Use

To ensure homogeneity, coating materials should be thoroughly stirred prior to use.

Application Conditions 

Temperature of air, substrate and coating material between 5 and 35°C and relative humidity below85%. The substrate temperature must be at least 3°C above dewpoint.

Application & Thinning: Brush

Use natural bristles, long hair brushes.

Application & Thinning: Roller

Not recommended.

Technical Data

• Density (g/cm³): 0,92
• Gloss Level: Gloss
• Corrosion Class: C1/C2 low protection
• Solids content in volume: 20%
• Heat Resistance: 100 °C (dry heat)

Dry Times By 20º C/RV 50%

• Touch dry: Remains tacky
• Dry to handle: Remains tacky
• Dry to recoat: After 30 minutes but within 24 hours
• Fully cured: 24 hours

Recommended Wet Film Thickness

20 μm

Recommended Dry Film Thickness 

2 μm

Theoretical Coverage 

50 m²/l

Practical Consumption

Practical coverage depends on many factors such as roughness of the substrate and material losses during application.

Safety Data 

• VOC level: 745 g/l
• VOC readymix: 745 g/l
• VOC category: A/h
• VOC limit: 750 g/l

Remarks regarding safety: Consult Safety Data Sheet and Safety Information printed on the can.