Orders before 12pm dispatched same day
Orders before 12pm dispatched same day
Rustoleum - Rust-O-Thane 9200 is a water-based satin gloss 2K polyurethane for a very durable and colour fast finish on metal or floors. Also ideal for doors, stairs, furniture, and as a topcoat for epoxy and acrylic systems.
Custom Colour
Please enter your required colour into the box below and click Submit ColourRustoleum - Rust-O-Thane 9200 is a water-based satin gloss 2K polyurethane for a very durable and colour fast finish on metal or floors. Also ideal for doors, stairs, furniture, and as a topcoat for epoxy and acrylic systems.
Recommended Use
RUST-O-THANE 9200 is intended for application on interior and exterior substrates which are coated with RUST-OLEUM epoxy or acrylic coatings (e.g. RUST-OLEUM: 9100 and 5401, Pegasol or Pegalink). The application area consists of coated floors, coated walls and primed metal.
Also ideal for use on stairs, doors, kitchen walls, floors and more. RUST-O-THANE 9200 assures appropriate protection against solvents, moderate alkalines, weak acids and chemical cleaning. Especially recommended where general urethane performance like excellent weather resistance (UV), easy cleaning and abrasion resistance is required.
Surface Preparation
Remove grease, oil and all other surface contamination using alkaline or high pressure (steam) cleaning in combination with appropriate detergents. Sand previous coatings that are in good condition to remove gloss and to roughen the surface slightly. Assure that the previous coating is compatible with the RUST-O-THANE 9200 by making a test application. Remove bad adhering coatings by scraping, wire brushing or sanding. (Spot) primewith commended Rust-Oleum or Mathys coatings. The surface must be clean and dry during application.
Directions For Use
Add activator gradually to base material and mix with a mechanical mixing device. Do not dilute during the pot-life. Do not use after 2 hours. Do not store residue of mixed product in a closed can.
Application Conditions
Temperature of air, substrate and coating material between 5°C and 35°C and relative humidity below80 %. The substrate temperature must be at least 3°C above dewpoint.
Application & Thinning: Brush
Use undiluted. Use natural bristles, long hair brushes.
Application & Thinning: Roller
Use undiluted. Use medium nap (polyamide, 8-12 mm). Apply slowly in even strokes.
Application & Thinning: Airless Spray
Use undiluted. Pneumatic and electric airless equipment. Tip size: 0.013-0.015 inch. Fluid pressure: 200 bar
Data sheet
Specific References
No customer reviews for the moment.