Corroless RF31 is a high solids glass reinforced, chemically resistant, two pack epoxy intermediate/finish.

Features

•  Excellent chemical resistance, withstands immersion in dilute solutions of non-oxidising acids, alkalis and salts.
• Cures down to 2°C
• Withstands splashes of oxidising acids or bleaching agents.
• Withstands most greases and immersion in oil.
• Withstands immersion in aliphatic solvents and splashes of aromatic solvents.
• Durable finish used for long-term performance both on and off shore.
• Gives excellent protection in urban, marine and industrial environments.

Thinners and Cleaning Solvent

 Corroless Thinners No.4. (Solvent Gun Wash may be used for cleaning only).

Surface Preparation

All surfaces when coated should be firm, clean, dry and free from all oil, grease, and other contamination. This is an intermediate or finish coat and should be applied over appropriate Corroless primers.

Recommended primer: Corroless EPF.
 
Application

Always follow the overcoating time for the selected primer.

Spraying

For conventional spray, an addition of up to 10% Corroless Thinners No.4 will be required.

Brushing

Apply unthinned, do not over brush.

Mixing

Mix each component separately prior to thoroughly mixing together for 2 to 3 minutes at medium speed. Always use a mechanical agitator. Ensure product is used only in the proportions recommended.

Overcoating

Overcoatable with itself, Corroless RF65. If overcoating time exceeds 24 hours and contamination has occurred, clean using a detergent solution/fresh water rinse and allow to dry before continuing. If maximum overcoating times are exceeded, abrade the surface and wash down with fresh water to remove contamination and allow to dry.