Axalta - Modified Vinyl - Primer/finish [Formerly Viterlac 305] is a one coat* vinyl anticorrosive primer/finish for galvanising.

Features

• Where a one coat*, sheen primer/finish is required 
• Can be applied to degreased new galvanising without the need for an etch primer
• Use for gates, fences, street furniture and structural steelwork
• Contains zinc phosphate anticorrosive pigmentation
• Resistant to weak acids and alkalis
• Highly moisture resistant
• Available in a wide colour range

Surface Preparation

All surfaces to be coated should be dry and cleaned as necessary to remove all oil, grease, salts, weld flux or other contamination. Where necessary, remove weld spatter and grind smooth all sharp edges and weld seams

• Galvanising: thoroughly degrease and lightly abrade any very shiny areas
• Steelwork: Blast clean to Sa2½ (ISO 8501-1:2007), surface profile 50-75 microns maximum

Mixing

Must be mixed thoroughly by using a mechanical agitator before use. Agitate periodically to ensure paint remains homogeneous. Thinner / Cleaner Axalta

Thinner

General Industrial TH004 (formerly called No.7 Thinner)

Application

Airless Spray: Output fluid pressure at tip 2000 psi, Tip Size 13-17 thou (0.33- 0.43 mm), some thinning may be required

Conventional spray – not recommended, as considerable thinning would be required for suitable atomisation and build would be greatly reduced 

Application by brush – supplied ready for use