Rustoleum Combicolor Aerosols are a one coat system based on a urethane modified alkyd. They contain rust-inhibitive pigments for additional corrosion protection to metal substrates. 

Features

• Primer and topcoat in one
• For application onto rust, bare metal
• High coverage: 10.5 m² per litre
• Sag resistant, no brush strokes
• White spirit dilutable

Recommended Use

Rustoleum CombiColor Aerosols High Gloss 7300 can be applied directly on bare, manually derusted or with CombiPrimer Anti-Corrosion 3369/3380 primed steel. Rustoleum CombiColor Aerosols High Gloss 7300 are intended for small maintenance jobs or for touch-up. Rustoleum CombiColor Aerosols High Gloss 7300 should be used in light industrial exposures, normal humidity and interior applications.

Surface Preparation

Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Prime or spot prime with the recommended Rustoleum Primers. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application. Galvanised, Zinc and Aluminium surfaces have to be primed first with CombiPrimer Tack Coat 3302.

Application Conditions

For optimum results the relative humidity shall be below 85% and the temperature of the can and substrate above 10°C.

Application & Thinning: Aerosol 

Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.