We use cookies to improve your experience on our website. By browsing this website, you agree to our use of cookies.  Learn More

    Maxkote M-Metal 100
    • Maxkote M-Metal 100

    Maxkote M-Metal 100

    Review (0)
    £90.75
    Tax excluded
    £108.90 Tax incl.

    Maxkote M-Metal 100 epoxy repair putty, engineering grade is used to repair metal components suffering material loss due to mechanical damage, erosion, corrosion or wear.

    Size :
    Quantity :
    • Secure Payments - Payments safe and secure as all transactions are encrypted to the highest global standard.
    • Delivery policy - We aim to ship all products same day where possible (Orders must be placed before 12pm)

    Maxkote M-Metal 100 epoxy repair putty, engineering grade is used to repair metal components suffering material loss due to mechanical damage, erosion, corrosion or wear.

    M-METAL 100 exhibits superior bond strength to grit-blasted surfaces but can also be used on manually prepared repairs areas.The product can be applied up to 20mm in a single application without shrinking. Once cured M-METAL 100 can be drilled tapped machined or sanded to suit the repair profile.

    Typical Uses

    • Worn or damaged pump shafts
    • Filling pitting corrosion
    • Resurfacing pump housings
    • Cracked pump or valve casings
    • Scored hydraulic rams
    • Worn bearing housings
    • Damaged flanges
    • Leaking tank seams
    • Worn keyways
    • Cracked engine blocks
    • Structural adhesive

    Surface Preperation

    Grit Blast:

    • All oil and grease must be removed from the surface using an appropriate cleaner such MEK or similar type solvent.
    • All surfaces must be abrasive blasted to ISO 8501/4 Standard SA2.5 (SSPC SP10/ NACE 2) minimum blast profile of 75 microns using an angular.
    • Once blast cleaned, the surface must be degreased and cleaned using MEK or similar type solvent.
    • All surfaces must be coated before gingering or oxidation.

    PLEASE NOTE: For salt contaminated surfaces the substrate must be pressure washed with clean water and checked for salt contamination, please refer to the surface preparation and pre-application guide for further information.

    Manual:

    • All oil and grease must be removed from the surface using an appropriate cleaner such as MEK.
    • All surfaces must be mechanically abraded using handheld grinders to ISO 8501/4 ST3 (SSPC SP3 ST3).
    • Once abraded, the surface must be degreased and cleaned using MEK or similar type material.
    • All surfaces must be repaired before gingering or oxidation occurs

    Application Method:

    • Using a spatula or applicator tool, apply the material to the prepared repair area.
    • Ensure the product is pressed into any holes, scars or cracks.
    • Once the repair has been completed smooth off any imperfections using a gloved hand with a little water.

    Maxkote
    MAX-MM100

    Specific References

    No customer reviews for the moment.

    Write your review
    Maxkote M-Metal 100

    2 other products in the same category:

    arrow_back
    arrow_forward
    Maxkote M-Metal 100

    Maxkote M-Metal 100

    £90.75
    Tax excluded
    £108.90 Tax incl.