Orders before 12pm dispatched same day
Orders before 12pm dispatched same day
Rustoleum 8300 is a single pack hygienic topcoat that protects against mild chemical exposure, occasional product spillage, frequent chemical cleaning, intermittent high humidity and moisture.
Rustoleum 8300 is a single pack hygienic topcoat that protects against mild chemical exposure, occasional product spillage, frequent chemical cleaning, intermittent high humidity and moisture.
Features
Recommended Use
8300 Topcoats should be applied on mineral substrates primed with Primer 8399. Resists mild chemical exposure, occasional product spillage, requent chemical cleaning, intermittent high humidity and moisture. Can be applied on 8399 or well prepared previous coatings. 8300 is classified Class 1 Surface Spread of Flame according to BS 476; part 7 : 1987.
Surface Preperation
New concrete, plastered or brick surfaces should cure and dry for at least 30 days prior to the application of coatings. Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam) cleaning. Wash total surfacewith plenty of fresh/warm water or high pressure (steam) cleaning in order to remove all remnants of contamination and cleaners ND14 or FK111. Sand previous coatings, which are in good condition to remove gloss and to roughen the surface slightly. Remove non-adhering old coatings. The surface must be clean and dry during application.
Directions For Use
To ensure homogeneity, coating materials should be thoroughly stirred prior to use.
Application Conditions
Temperature of air, substrate and coating material between -10° and 35°C and relative humidity below85%. The substrate temperature must be at least 3°C above dewpoint. Below0°C the surface should be free from ice.
Application & Thinning: Brush
-10 to 5°C: 10-15% volume RUST-OLEUM Thinner 633.
> 5°C: Up to 10% volume RUST-OLEUM Thinner 633. Use brushes based on a mixture of synthetic/natural bristles.
Application & Thinning: Roller
-10 to 5°C: 10-15% volume RUST-OLEUM Thinner 633.
> 5°C: Up to 10% volume RUST-OLEUM Thinner 633. Use medium nap polyamide 8-12 mm rollers. Roller application may require 2 coats to achieve recommended d.f.t.
Application & Thinning: Airless Spray
-10 to 5°C: Up to 10% volume RUST-OLEUM Thinner 160.
> 5°C: up to 15% volume RUST-OLEUM Thinner 633. Pneumatic and electric airless equipment. Tip size: 0.011-0.017 inch. Fluid pressure: 150 - 200 bar. Lowtemperatures may affect the atomising properties.
Application & Thinning: Air-Atomised Spray
-10 to 5°C: Up to 10% volume RUST-OLEUM Thinner 160.
> 5°C 10-15% volume RUST-OLEUM Thinner 633. Gravity cup and pressure cup. Tip size: 1.2 -1.8 mm. Atomising pressure: 2 - 4 bar.
Data sheet
Specific References
No customer reviews for the moment.