Orders before 12pm dispatched same day
Orders before 12pm dispatched same day
Rustoleum - 5090 Anti-Condensation Coating is a water-based single pack hygienic topcoat protects against discontinuous steam or water vapour formation, in order to prevent condensation and dripping.
Rustoleum - 5090 Anti-Condensation Coating is a water-based single pack hygienic topcoat protects against discontinuous steam or water vapour formation, in order to prevent condensation and dripping.
Features
Recommended Use
Rustoleum 5090 should be used on ceilings and the upper parts of walls and is intended for 1 coat, airless application. The product can also be applied by brush or roller, 2 -3 coats, resulting in a textured finish. Can be used where discontinuous steam or water vapour formation occurs, in order to prevent condensation and dripping. 1 Litre product will, after drying, absorb at least 400 grams of water. Old coatings should be humidity resistant. Approvals: absorption by Ceripec.
Surface Preperation
New concrete or brick surfaces should cure and dry for at least 30 days prior to application of the coating. Repair surface defects of (coated) concrete or brick surfaces. Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam) cleaning. Scrape and wire brush carefully to remove deteriorated coatings. Sand previous coatings which are in good condition to remove gloss and to roughen the surface slightly. The surface may be slightly damp during application.
Directions For Use
To ensure homogeneity, coating materials should be thoroughly stirred prior to use.
Application Conditions
Temperature of air, substrate and coating material between 5 and 35°C and relative humidity below85%. The substrate temperature must be at least 5°C above dewpoint.
Application & Thinning: Brush
Up to 5% volumewater. Use a distemper brush.
Application & Thinning: Roller
Up to 5% volumewater. Use a medium nap (10-15 mm), polyamide roller. For textured surfaces use long nap 14-18 mm rollers.
Application & Thinning: Airless Spray
If required up to 5% volumewater. Pneumatic and electric airless equipment. Tip size: 0.018-0.024 inch (use reverse tips). Fluid pressure: 130 - 200 bar. Checkwet film thickness, avoid excessive film thickness.
Technical Data
Theoretical Coverage
1 m²/l
Data sheet
Specific References
No customer reviews for the moment.