Impralan Topcoat D100 is a water based top coat with extremely high covering power and weather resistance.

Recommended Use

For interior and exterior wooden components, especially for dimensionally stable wooden components such as windows

Features

• Very good hiding power 
• Highly elastic and block resistant 
• Highly weather resistant 
• Very good edge coverage 
• Mild inherent odour 
• Proof of suitability according to DIN EN 927-2, analogous to topcoat D150 
• Tested according to DIN EN 71-3 "Safety of toys 
• Fast drying 
• Density approx. 1.200 g/cm³ at 20° C

Surface Preparation

The substrate must be clean, solid and load-bearing. The wood moisture content should be 12% - 14%. If necessary, wash with universal thinner beforehand.

Depending on the requirements of DIN 68800, protect exterior wood against blue stain and rot with an impralan primer containing active ingredients.

Application Instructions

Stir well before use. Use a suitable abrasive for intermediate sanding (grit 180-220). To avoid uneven moisture absorption, coat all sides of wooden components. Do not apply and dry below + 10° C (ambient air, substrate, and material) and not in direct sunlight.

The compatibility of sealants with impralan topcoats must be checked. Sealants based on silicone or butyl rubber are suitable. The adhesion of sealants for connection joints must be checked in advance on the coating.

When used on woods with a high content of wood ingredients, such as meranti or oak, discolouration may occur. In this case, an insulating intermediate coat is required.