Resideck Rapid Floor Patch is a fast curing, high strength, trowel applied, three component Methacrylate Resin mortar, designed for rapid and permanent repairs to concrete and masonry surfaces.

Usage & Highlights 

Repairs to spalled or damaged concrete; bedding pre-cast concrete beams; chemical bunds; floor repairs.Ultra-fast curing.

• Resilient
• Very good chemical resistance
• Excellent adhesion
• Fast curing, even at low temperatures
• Impact and abrasion resistant
• Frost resistant and impervious to water
• Excellent mechanical properties

Surface Preparation

Remove all laitance, spalled concrete, grease, oil, dust, and other contaminants by scabbling, bush hammering, or other mechanical treatment, to provide a sound clean substrate.

Any exposed reinforcing steel shall be fully exposed by cutting out around its full circumference and cleaned by hand abrading or wire brushing to remove rust, scale, etc., and primed with a coat of Resideck Primer.

Priming

The prepared concrete surface, together with the pre-primed re-bars, shall be primed by the application of Resideck Primer.

The mixed Resideck Primer should be applied by brush or roller at a nominal rate of 0.2 – 0.3kg/m², depending upon surface profile. Allow the primer to cure for a minimum of 40 minutes.

Mixing

Resideck Rapid Floor Patch is supplied as a three component product consisting of the BASE component, the CATALYST component and the AGGREGATE component.

The contents of the BASE and CATALYST component should be thoroughly mixed together and the AGGREGATE then introduced.

A low speed drill stirrer or a forced action mixer such as a Mixall, Pennine or Creteangle type, will be suitable.

Application

Resideck Rapid Floor Patch should be applied by tamping and trowelling to ensure good compaction and a tight finish.

The material should not be feather edged.

Minimum application thickness is 4mm.