- New
Orders before 12pm dispatched same day
Orders before 12pm dispatched same day
Rust-Oleum 9100 High Solids Epoxy is Two-pack, high layer thickness glossy epoxy, resistant to corrosion and chemicals, suitable for applications on metal or floors.
Custom Colour
Please enter your required colour into the box below and click Submit ColourRust-Oleum 9100 High Solids Epoxy is Two-pack, high layer thickness glossy epoxy, resistant to corrosion and chemicals, suitable for applications on metal or floors.
Recommended Use
9100 high Performance can be applied on: manually prepared rusted steel surfaces, new, blasted, primed steel; concrete and previously compatible coated surfaces. 9100 Topcoats offer appropriate protection against strong chemicals, acids, alkalis and solvents; frequent product spillage and chemical cleaning; high humidity and moisture conditions.
Features
Recommended System
Topcoat: for U.V. resistance: polyurethane Topcoats 9200 should be applied (except for the clear coatings).
Primers: porous mineral substrates: 5401 or 5421 Impregnation Primer.
Very dense substrates, like ceramic tiles: Super Adhesive 3333.
9100 Topcoats can be applied on 9169 and 9180 Metal Primers.
Surface Preparation
Remove all dirt and contaminations by alkaline or high pressure (steam) cleaning in combination with appropriate detergent like Rust-Oleum ND14. Sand previous glossy coatings to roughen the surface slightly, check compatibility. The surface must be clean and dry.
Steel: Remove loose rust, mill scale and deteriorated coatings by hand or power tool cleaning to St 2/3 (ISO 8501-01 : 1988). Blast large areas to Sa 2 (ISO 8501-01: 1988), blast profile max. 50 µm. For immersion purposes, prepare to Sa 3 (ISO 8501-01 : 1988), blast profile max. 75 µm.
Concrete and masonry: New concrete or masonry should cure for at least 30 days before applying the coating system. Remove laitance, any loose or unsound concrete or coatings. Smooth concrete should be abraded except in case of use of a Rust-Oleum adhesion primer.
Application & Thinning: Brush
Use natural bristles, long hair, preferably disposable brushes. Dilute up to 10% volume with Thinner 160 (do not dilute 9101HS).
Application & Thinning: Roller
Use a medium nap polyamide 16-20 mm disposable rollers. Roller application requires 2 coats to achieve recommended d.f.t. Dilute up to 10% volume with Thinner 160 (do not dilute 9101HS)
Application & Thinning: Airless Spray
Tip size: 0.013-0.021 inch. Fluid pressure: 150 - 225 bar. Avoid excessive film thickness. Up to 10% volume Thinner 160 (do not dilute 9101HS)
Application & Thinning: Air-Atomised Spray
Not recommended.
Cleaning Of Equipment / Spills
RUST-OLEUM Thinner 160.
Data sheet
Specific References
No customer reviews for the moment.