Rustoleum - Nr.1 Green is a highly effective paint stripper for the quick removal of layers of old paint and glue from metal, mineral and wooden substrates.

Features

• Far more effective than other green paint strippers on the market
• Gel like paste works better than liquid alternatives
• Apply as low as 0°C
• Also effective as glue remover
• Quick results

Recommended Use

Nr. 1 Green Paint Stripper can be used for a quick removal of layers of old paint and glue. Green Paint Stripper is developed to remove all types of oil- and alkyd based paints, emulsion paints, varnish and most two-component materials from metal, mineral and wooden surfaces. Does not contain methylene chloride, NMP, acids, alkali's, biocides and conservation additives. It will not affect metal, mineral or wooden substrates.

Surface Preperation

Remove loose coatings as much as possible by scraping.

Directions For Use

Can: To release possible pressure open the can carefully.

Aerosol: Remove cover cap. Shake vigorously before use.

Application Conditions

Temperature of air, substrate and material between 0 and 30°C and relative humidity below 85%.

Application & Thinning: Brush

Apply Green Paint Stripper thickly in an even layer with a brush (disposable brush, flat or round). Do not use synthetic brushes. Allowto stand for 10 to 15 minutes, and remove the old layer with a filling knife or paint scraper. Thick layers of some (two-component) products may need an additional treatment. After use, clean the surfacewith a cleaner (f.e. ND 14), high pressure (steam) cleaning, fresh water and allowto dry completely before applying a coating.

Application & Thinning: Aerosol

Hold the can approx. 10-20 cm from the substrate. Apply a uniform foam layer of Paint Stripper 2925; allowstanding for minimal 15 minutes, and removing the old layer with a filling knife or paint scraper. Thick layers of some (two-component) products may need an additional treatment. After use, clean the surfacewith cleaner/degreaser, fresh water or white spirit and allowdrying completely before applying a coating.