PPG - Novaguard 260 is a two component, high build, amine adduct cured, phenolic epoxy holding primer/ tank coating with excellent resistance to alcohols, fats, solvents and various other chemicals.

Best Uses

PPG Nvaguard 260 offers excellent application properties that's ensures you will produce a high quality smooth surface that adheres to the surface supper efficiently.

Features

• Tank coating with excellent resistance to alcohols, fats, solvents and various other chemicals*
• Can be used as holding primer for all solvent-free epoxy and novolac tank coatings 
• Can be used for hot water and hot oil storage up to 90°C (195°F)
• Good application properties, resulting in a smooth easy cleanable surface
• Can be applied and cures at temperatures down to 5°C (41°F)
• Good abrasion resistance

Instructions For Use

Mixing ratio by volume: base to hardener 87:13

• The temperature of the mixed base and hardener should preferably be above 15°C (59°F), otherwise extra thinner may be required to obtain application viscosity
• Adding too much thinner results in reduced sag resistance and slower cure 
• Thinner should be added after mixing the component

Application

Air spray

Recommended thinner

THINNER 91-92

Volume of thinner 5 - 10%, depending on required thickness and application conditions

Nozzle orifice

2.0 mm (approx. 0.079 in)

Nozzle pressure

0.3 MPa (approx. 3 Bar; 44 p.s.i.)

Airless spray

Recommended thinner

THINNER 91-92

Volume of thinner 5 - 10%, depending on required thickness and application conditions

Nozzle orifice

Approx. 0.48 – 0.53 mm (0.019 – 0.021 in)

Nozzle pressure

15.0 MPa (approx. 150 bar; 2176 p.s.i.)

Brush/roller

Only for touch-up and spot repair

Recommended thinner

THINNER 91-92

Volume of thinner 0 – 5%

Cleaning solvent

THINNER 90-53