Resideck Rapid Joint Seal is a coloured, two pack, pourable, flexibilised Epoxy sealant. The consistency of the mixed sealant allows direct poring of the sealant into horizontal joints.

Resideck Rapid Joint Seal is hard and touch enough to protect arris edges from heavy wheel loading,but possesses sufficient flexibility to accommodate a degree of movement (10% of the joint width). Resideck Rapid Joint Seal is particularly suitable for filling saw cut joints in long strip floor construction. 

Usage & Highlights

To seal floor joints in food factories and warehouses where heavy vehicular trafficking occurs.

• No Primer required
• Excellent adhesion to concrete
• Tough and resilient
• Suitable for wide joints
• Highly resistant to water
• Easy to apply
• Fast curing
• Hygienic and easily cleanable
• Low viscosity

Surface Preparation

New concrete floors shall be a minimum of 21 days old. Joint surfaces shall be sound, clean and free from laitance, dust and other contaminants. 

Joint arises are best prepared by grinding or power wire-brushing; ensuring that all spoil and residual dust is removed by blowing with dry, oil free, compressed air.

De-bonding tape should be used in the base of the joints otherwise a polyethylene foam backing strip should be inserted to the appropriate depth.

Mixing

Pour the contents of the CURING AGENT container to the BASE container and thoroughly mix, preferably by mechanical means until a uniform consistency is achieved.

Application

The mixed material may be poured directly into the prepared joints to level.

Alternatively, Resideck Rapid Joint Seal may be poured into empty cartridge tubes and gunned into the joints using a sealant gun. It may be necessary to top up to level after a few minutes when the sealant into irregularities.