- New
Orders before 12pm dispatched same day
Orders before 12pm dispatched same day
Rust-Oleum 9180 Epoxy Metal Primer is a high build metal primer based on two-component epoxy resins offer extra protection against corrosion on bare or blasted metal.
Rust-Oleum 9180 Epoxy Metal Primer is a high build metal primer based on two-component epoxy resins offer extra protection against corrosion on bare or blasted metal.
Recommended Use
Grey Primer 9180 should be used on bare steel, on blasted steel and properly prepared galvanized substrates or as an intermediate coat. 9180 Primer can be recoated with 9100 Topcoats assuring the appropriate protection against corrosion, strong chemicals, acids, alkalis and solvents; frequent product spillage and frequent chemical cleaning; high humidity and moist conditions.
Features
Surface Preparation
Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam) cleaning in combination with appropriate detergents. For optimum results remove rust, rust scale, mill scale and deteriorated coatings by abrasive blasting to Sa 2½ (ISO 8501-01 :1988), blast profile max. 50 µm. Salts, "white rust" (on galvanised steel), etc. should be removed by washing with Surfa-Etch 108 Etching Solution or by sweep blasting. Sand previous coatings, which are in good condition to remove gloss and to roughen the surface slightly, check compatibility. From surfaces to be submerged all previous coatings should be removed by abrasive blasting to Sa 3 (ISO 8501-1 : 1988), blast profile max. 50µm. New concrete should cure and dry for at least 30 days prior to application of the coating. The surface must be clean and dry during application
Application & Thinning: Brush
Dilute up to 10% volume RUST-OLEUM Thinner 160. Use natural bristles, long hair brushes. Touch-up or small areas only. Preferably use disposable brushes.
Application & Thinning: Roller
Dilute up to 10% volume RUST-OLEUM Thinner 160. Use short/medium nap polyamide 8 mm rollers. Preferably use disposable rollers. Roller application may require 2 coats to achieve recommended d.f.t.
Application & Thinning: Airless Spray
5-15% volume RUST-OLEUM Thinner 160. Pneumatic and electric airless equipment. Tip size: 0.013-0.018 inch. Fluid pressure: 150 - 250 bar.
Application & Thinning: Air-Atomised Spray
Up to 20% volume RUST-OLEUM Thinner 160. Spray: Gravity cup and pressure cup. Tip size: 1.2 -2.2 mm. Atomising pressure: 2 - 4 bar.
Cleaning Of Equipment / Spills
Data sheet
Specific References
No customer reviews for the moment.