Rustoleum Hard Hat® Heat Resistant 1015 and 1078 paints are Heat Resistant Coatings based on a silicone modified alkyd resin.

Features

• For continuous temperatures up to 650°C
• For peak temperatures up to 750°C
• For on bare metal or slightly rusted surfaces
• Ideal for engines, heat cannons, pipes, vents, etc.
• To handle after 3 hours (at 20°C)

Recommended Use 

HARD HAT® Heat Resistant Coating can be applied on new, bright or shot-blasted steel or well pre-treated coated surfaces such as barbecues, boiler fittings, hot air cannons, exhausts, etc. HARD HAT® Heat Resistant Coating is intended for small maintenance jobs and repairs. HARD HAT® Heat Resistant Coating provides protection up to a dry heat of 750°C (shorttermpeak load) for applications indoors or in a sheltered outdoor environment.

Directions For Use

To ensure homogeneity, coating materials should be thoroughly stirred prior to use.

Application Conditions

Only apply if the air and surface temperatures are between 5 and 35°C and the relative humidity is less than 85%. The temperature of the coated surface must be at least 3°C above the dewpoint.

Application & Thinning : Brush

No thinning

Application & Thinning : Roller 

No thinning. Use shorthaired polyamide (perlon 8 - 12 mm) rollers

Application & Thinning: Air-Atomised Spray

Dilute up to 10 to15% volume RUST-OLEUM Thinner 7301

Application & Thinning: Aerosol 

Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use. Hold can approx. 30 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.