We use cookies to improve your experience on our website. By browsing this website, you agree to our use of cookies.  Learn More

    Parex - CS Grout
    • Parex - CS Grout

    Parex - CS Grout

    Review (0)
    £15.80
    Tax excluded
    £18.96 Tax incl.

    CS Grout is a Portland cement based product giving high strength, good flow and non-shrink properties. Placed grout gives structural support and good vibration resistance.

    Size :
    Quantity :
    • Secure Payments - Payments safe and secure as all transactions are encrypted to the highest global standard.
    • Delivery policy - We aim to ship all products same day where possible (Orders must be placed before 12pm)

    CS Grout is a Portland cement based product giving high strength, good flow and non-shrink properties. Placed grout gives structural support and good vibration resistance.

    CS Grout is chloride free and can be safely used in contact with steel. The specialised mix design enables placement at low water content leading to good freeze-thaw stability, low water absorption plus resistance to oil, sea water and mild alkali attack.

    Placement thickness may be in the nominal range of 10mm to 100mm. For thicker sections 6mm Aggregate should be added at a rate of up to one to one Aggregate to CS Grout.

    Recommended Use

    • Crane rail tracks
    • Stanchion bases
    • Machine bed plates 
    • Dowel bars between pre-cast units
    • Ground anchors 
    • Bridge Bearing Supports

    Application

    Preparation

    Formwork should be erected and made grout-tight. The formwork must be designed with sufficient hydrostatic head to ensure grout flow into and across the grouting area. Saturate the grouting area with water. Leave for 1 hour and then blow out any surplus water.

    Mixing

    Pour 4.5 litres of clean water into the mixing vessel for each complete bag of CS Grout to be used. Slowly add the powder to the water whilst continually mixing. Mechanical mixing should be carried out using either a high torque slow speed drill with a Grout Stirrer or a grout mixer set on slow speed. (High speed or colloidal mixing will cause thixotropy leading to loss of flow.)

    Placing

    Grout should be placed within 20 minutes of mixing. Continuous placing is important, pouring from one side of the formwork until the grout appears at the opposite side of the grouting area. Do not disturb once grouting has been completed. CS Grout may be placed at temperatures between 5°C and 45°C. For placing at temperatures outside this range contact the Technical Service Department.

    Curing

    Placed grout, which is exposed, should be cured in accordance with good concrete practice including water spray or the spray applied curing membrane Polycure.

    Parex
    PAR-CSG

    Specific References

    Data Sheets Available for Download:


    No customer reviews for the moment.

    Write your review
    Parex - CS Grout

    16 other products in the same category:

    arrow_back
    arrow_forward
    Parex - CS Grout

    Parex - CS Grout

    £15.80
    Tax excluded
    £18.96 Tax incl.