Axalta - Viterclad 50 is a two pack recoatable polyurethane finish specially formulated for the maintenance and repainting of architectural cladding.

Features

• Recommended for the maintenance of Corus Colorcoat HP200* and HPS200* cladding
• Expected system lifetime up to 15 years (depending on exposed environment and shade)
• Suitable for PVF2, Silicone Polyester & Polyester Cladding when applied over ViterClad Bonding Coat
• Suitable for urban, marine and industrial environments
• Tough, durable finish combining abrasion resistance with outstanding colour and sheen retention
• Good cleaning properties for ease of building maintenance
• Cures at sub-zero temperatures and has good climatic tolerance
• Tolerant of slight surface moisture during application

Surface Preparation

• This product is a finish coat which should be applied over ViterClad Bonding Coat or suitably prepared, sound Plastisol for recolour work
• For aged/degraded Plastisol, condition diagnosis and correct surface preparation are critical to performance. Please consult Axalta Coating Systems for individual project specifications
• Completely new and unweathered HP200* Plastisol must be wiped with white spirit (1050 Thinner) and allowed to dry prior to applying ViterClad 50
• New HPS200* Plastisol must be wiped with xylene (1006 Thinner) and allowed to dry prior to applying ViterClad 50
• For PVF2, Silicone Polyester and other cladding types, refer to Axalta Coating Systems
• Surfaces should be clean, dry and free from all grease, oil and general contamination

Mixing

Mix only in the proportions stated, mixing each component individually then together using a mechanical agitator. Agitate periodically during use to ensure product remains homogeneous.

Thinner

Thinner: 1737

Thinner Equipment Cleaner: 1737 Thinner

Application Methods

• Airless Spray: Output fluid pressure at tip 2200-2500 psi, Tip Size: 13-17 thou (0.33- 0.43mm). Up to 5% 1737 Thinner may be added for application under cool or hot conditions, but thinning should be avoided if possible
• Conventional spray is possible but not recommended
• Brush – up to 5% 1737 Thinner may be required 
• Roller – use only good quality short hair roller types of suitable width to accommodate the cladding profile and configuration – always work from a wet edge.