Axalta - ViterWall 261 is an epoxy, solvent-free gloss steel coating. Perfect for use on walls and steelwork.

Features and Use:

• Excellent chemical and solvent resistance finish-coat, together with high impact and abrasion resistance.
• Easily cleaned coating for use in food and pharmaceutical plants, chemical plants and aggressive industrial environments.
• Low odour – may be applied in poorly ventilated areas where solvent fumes would be undesirable.
• Suitable for application onto concrete or structural steelwork.
• Can be applied on site.

Surface Preparation:

• This product is a finish-coat and should be applied over an appropriate primer or intermediate coating – consult Spencer Coatings for a detailed specification.
• All surfaces to be coated with the Axalta - ViterWall 261 Gloss Steel Coating should be dry and cleaned as necessary to remove all oil, grease, salts or other contamination.

Mixing:

• Must be mixed thoroughly by using a mechanical mixer (with side scraper) before use. Add hardener in the correct proportions and mix thoroughly for a minimum of 2 minutes. Mix the material just before use, and consider the area to be coated and pot life of the material when deciding how many units are required.
• Note: do not scrape or pour out remaining residues of mixed material from the bottom and sides of the container onto the floor, as this material may be incompletely mixed and cause ‘soft spots’ in the applied floor coating.
• It is recommended that all material is stored at a temperature of approximately 20ºC for at least 24 hours prior to use, to aid mixing and application.

Application Conditions:

Only apply in conditions of good ventilation which must be maintained during drying and curing. Do not apply when rain, mist, sleet or snow are imminent. During application and drying time of the paint coating, the surface should be dry, the Relative Humidity should not exceed 85% and the steel temperature should remain at least 3oC above the dew point. Only apply this product when the above conditions can be maintained throughout the critical application and drying/curing process. Paint temperature should ideally be at a minimum of 15ºC.

Contact us today for help and advice via our website or contact page. Maker Coating Systems has been supplying high quality products to customers for decades, so you can rely on our team of advisors to help you find the right product for the job.