Tor - Unicover W has been developed as a cost effective means of extending the life of walls, external cladding and tackling cut edge corrosion, whilst beautifully transforming its appearance in the process.
Custom ColourPlease enter your required colour into the box below and click Submit Colour
You can find our colour charts here
Secure Payments - Payments safe and secure as all transactions are encrypted to the highest global standard.
Delivery policy - We aim to ship all products same day where possible (Orders must be placed before 12pm)
Tor - Unicover W is a high build protective finish for the renovation of factory coated profile metal vertical cladding panels, roofing trims etc in moderate environmental locations. product description Single pack smooth finish based on a specially modified acrylic/urethane resin system containing inert pigments and extenders.
- Long-term protection
- Easily applied
- Fast application
- Colour matching
Brush or airless spray (can be roller applied to large flat panels etc). Stripe coat all vulnerable areas, (edge, panel ends, bolt heads, etc) and allow to dry overnight before main coat application. Apply two full coats as necessary. Ensure good coverage especially vulnerable areas
Inspect all elevations of the building - condition of (say) North and South facing cladding may differ considerably. Ensure surfaces are sound, clean and dry before coating, and any existing coatings are sufficiently resilient for overcoating. Remove surface contaminants by detergent scrubbing or high pressure power washing. Remove any moss, lichen, algae etc using Torkill W Fingicidal Solution (DM405). Ensure any existing coatings are adhering firmly to the substrate. Remove any residual chalking (if present) by vigorous rubbing etc with a fine scouring pad, and any other surface leachates or residues (particularly on plasticised PVC coatings) by either vigorous wiping with Tor TH99 solvent or vigorous scrubbing with strong alkali detergent (eg. Torstrip WDA 10) followed by thorough rinsing.
Note: Abrasion of PVDF coatings (other than around loose or corroded areas) with fine hard abrasives should be avoided as this may polish the surface and impair adhesion of subsequent coatings - white aluminium oxide (80 mesh or coarser) or other suitable hard sharp mineral abrasive paper recommended to ‘cut’ and roughen coatings.
Scrape back any loose or weakly bonded materials and prepare to a firm feathered edge, and abrade exposed metal to remove corrosion products and provide a mechanical "key". Spot prime all bare metal areas with Elastaseal Z Metal Primer (RC145) as appropriate.
- Tintable to many colours
- For Use On
- Application Method
- Brush, Roller, Airless Spray
- Recoat Time (20°c)
No customer reviews for the moment.