We use cookies to improve your experience on our website. By browsing this website, you agree to our use of cookies.  Learn More

    Parex - Epoxy Mortar E

    Review (0)

    Parex Epoxy Mortar E is an epoxy resin based mortar suitable for placing using hand tools. The three pack product consists of a resin base, a bottle of hardener and a bag of specially graded fillers.

    Please ring 01392 822600 for availability

    Size :
    Standard Colours :
    Quantity :
    • Secure Payments - Payments safe and secure as all transactions are encrypted to the highest global standard.
    • Delivery policy - We aim to ship all products same day where possible (Orders must be placed before 12pm)

    Parex Epoxy Mortar E is an epoxy resin based mortar suitable for placing using hand tools. The three pack product consists of a resin base, a bottle of hardener and a bag of specially graded fillers.

    Features

    • Repairs to concrete beams, columns, floors and walls.
    • Support of precast concrete and steel units.
    • Placed support for stanchion bases.
    • Placed support for bridge bearings.

    Preparation

    Remove all loose material, plaster, paint and oily deposits to produce a sound clean surface. Roughen smooth concrete to give a good mechanical key. Cut back repair edges to avoid feather edging. Expose reinforcing steel two thirds of its circumference in a sound concrete background. Totally expose steel in areas where concrete repairs are deeper than the steel embedment depth. Clean back corroded reinforcing steel to bright metal. Protect cleaned steel with Steel Primer.

    Priming

    Using Bondcoat UF, pour all of the contents of the hardener bottle into the resin tub and mix thoroughly until homogeneous. Apply a thin continuous coat of mixed primer to the work area using a stiff bristle brush. Place the mixed Epoxy Mortar E, see section below, within 30 minutes of priming. If primer is absorbed by a porous substrate, re-prime before applying mortar.

    Mixing

    The mixing of Epoxy Mortar E should be carried out with full packs only. Pour all of the resin and hardener into a clean vessel. Mix with a slow speed high torque drill and Mortar Stirrer until homogeneous. Add the filler slowly whilst continuously mixing. After all filler has been added, mix for a further one minute. For larger quantities place the mixed resin system into a suitable mixer such as the Mixal or Creteangle. Start to mix and slowly add the filler. When all the filler has been added, mix for a further one minute.

    Placing

    Place the mixed material onto the primed surface using a clean trowel or other suitable hand tool. Ensure that the applied mortar is worked well into repair edges and any irregularities. A smooth surface finish may be achieved using a steel float moistened with Solvent. Place in layers of approximately 10mm to 50mm. Where thicker layers are required to be built up, the surface of the under layer should be left with a wood float finish and should be scored. Subsequent primer and mortar layers may be applied as soon as the initial layer is firm enough not to distort under the new work.

    Epoxy Mortar E may be placed at temperatures between 5°C and 35°C. For placing at temperatures outside this range contact the Technical Service Department. Tools and mixing equipment should be cleaned with Solvent before the Epoxy Mortar E has started to harden.

    Parex
    PAR-EME-2

    Data sheet

    Type
    Epoxy
    Size
    16KG
    Finish
    Natural
    For Use On
    Concrete
    Application Method
    Hand Placed
    Interior/Exterior
    Exterior

    Specific References

    No customer reviews for the moment.

    Write your review
    Parex - Epoxy Mortar E

    16 other products in the same category:

    arrow_back
    arrow_forward

    Parex - Epoxy Mortar E