Coo-Var Dampshield is a two component resin membrane that is tolerant to residual moisture in concrete floors.This enables earlier access onto the floor than would otherwise be available for the application of screeds, coatings and other floor coverings including carpets, tiles, vinyl and wood.

Being solvent free it is low odour during application which allows usage in areas where taint could be a problem.

Coo-Var Dampshield can be used on concrete floors and fine concrete screeds, in the case of unbonded screeds this should not be less than 50mm thick.The surface must be of sufficient quality, continuity and mechanical strength to ensure even coating.

Wet Film Thickness

230 microns

Dry Film Thickness

230 microns

Drying Time: @ Recommended D.F.T

Touch dry: 24 hours @ 20 °C

Hard dry: 72 hours @ 20 °C

Full hardness: 5 to 7 days @ 20 °C

Surface Preperation:

Concrete surfaces must be prepared by scarifying, vacuum shot-blasting, planing or other suitable method. All traces of concrete hardeners or other contaminants must be removed. The surface must be thoroughly vacuumed to remove concrete dust and then protect against further contamination by suitable means. Surfaces must be free from liquid, water, and the atmosphere must not be condensing.

Mixing Instructions:

Mix the contents of the hardener component with the base thoroughly using a slow speed power strirrer.

Application Conditions:

As dictated by normal good painting practice. Do not apply if the temperature is likely to drop below 10 °C during application or during the drying process.

Contact us today for help and advice via our website or contact page. Maker Coating Systems has been supplying high quality products to customers for decades, so you can rely on our team of advisors to help you find the right product for the job.